Aggregates Filter Press References

AGGREGATES FILTER PRESS REFERENCES

JWK filter presses be installed in the aggregates industry for Indonesia, Malaysia, Vietnam, Thailand, Australia, India, Columbia, etc.

Benefits as: 

Eliminate the requirement for settling ponds

Reduce the space required to accommodate your washing plant

Maximize recycling of water from your washing plant

Max recovery of material through silt removal

Eliminate waste from your washing & classifying plant

Very low residual water content

Significantly reduce health & safety risks on site

Cake thickness from 30 to 60mm.

Feed pressure from 6 - 16 bars

Dewatering Capacity is more than 1000 t/d

24 hours unattended

Dual slurry feed inlets lower inlet velocity and results in less wear on filter cloths.

Open filtrate design allows for simple and rapid identification of bad filter cloths.

Siemens PLC with fully automated controls and remote monitoring/assistance.

Wider plate openings allow for better cake release and easier inspection and maintenance.

The filter press, to include as standard:

Main unit, beam steel structure, sealing hydraulic cylinder, head piece, end piece, multi-plates shifting, pull-wire switch, Remote Control.

Hydraulic power unit,

Electrical control panel, Siemens PLC and HMI, DCS communication.

Complete set of plate pack and cloth.

Options to include:

Bomb doors / Drip tray / Swivel plate/

Header piece piping and valves – Slurry feeding valve, Core blowing valve, etc.